Journal cover Journal topic
Atmospheric Measurement Techniques An interactive open-access journal of the European Geosciences Union
Journal topic

Journal metrics

Journal metrics

  • IF value: 3.248 IF 3.248
  • IF 5-year value: 3.650 IF 5-year 3.650
  • CiteScore value: 3.37 CiteScore 3.37
  • SNIP value: 1.253 SNIP 1.253
  • SJR value: 1.869 SJR 1.869
  • IPP value: 3.29 IPP 3.29
  • h5-index value: 47 h5-index 47
  • Scimago H index value: 60 Scimago H index 60
Volume 9, issue 10 | Copyright
Atmos. Meas. Tech., 9, 4997-5006, 2016
https://doi.org/10.5194/amt-9-4997-2016
© Author(s) 2016. This work is distributed under
the Creative Commons Attribution 3.0 License.

Research article 11 Oct 2016

Research article | 11 Oct 2016

Radiocarbon analysis of stratospheric CO2 retrieved from AirCore sampling

Dipayan Paul1, Huilin Chen1,2, Henk A. Been1, Rigel Kivi3, and Harro A. J. Meijer1 Dipayan Paul et al.
  • 1Centre for Isotope Research, Energy and Sustainability Research Institute Groningen, University of Groningen, Nijenborgh-4, 9747 AG Groningen, the Netherlands
  • 2Cooperative Institute for Research in Environmental Sciences (CIRES), University of Colorado, Boulder, Colorado, USA
  • 3Finnish Meteorological Institute, Arctic Research, Sodankylä, Finland

Abstract. Radiocarbon (14C) is an important atmospheric tracer and one of the many used in the understanding of the global carbon budget, which includes the greenhouse gases CO2 and CH4. Measurement of radiocarbon in atmospheric CO2 generally requires the collection of large air samples (a few liters) from which CO2 is extracted and then the concentration of radiocarbon is determined using accelerator mass spectrometry (AMS). However, the regular collection of air samples from the stratosphere, for example using aircraft and balloons, is prohibitively expensive.

Here we describe radiocarbon measurements in stratospheric CO2 collected by the AirCore sampling method. AirCore is an innovative atmospheric sampling system, which comprises a long tube descending from a high altitude with one end open and the other closed, and it has been demonstrated to be a reliable, cost-effective sampling system for high-altitude profile (up to  ≈ 30km) measurements of CH4 and CO2. In Europe, AirCore measurements have been being performed on a regular basis near Sodankylä (northern Finland) since September 2013. Here we describe the analysis of samples from two such AirCore flights made there in July 2014, for determining the radiocarbon concentration in stratospheric CO2. The two AirCore profiles were collected on consecutive days. The stratospheric part of the AirCore was divided into six sections, each containing  ≈ 35µg CO2 ( ≈ 9.6µgC), and stored in a stratospheric air subsampler constructed from 1∕4in. coiled stainless steel tubing ( ≈ 3m). A small-volume extraction system was constructed that enabled  > 99.5% CO2 extraction from the stratospheric air samples. Additionally, a new small-volume high-efficiency graphitization system was constructed for graphitization of these extracted CO2 samples, which were measured at the Groningen AMS facility. Since the stratospheric samples were very similar in mass, reference samples were also prepared in the same mass range for calibration and contamination correction purposes. The results show that the Δ14CO2 values from tropopause up to about 19(±1)km for the sample collected on 15 July was 18 ± 6‰ (samples 1–4), very similar to the current tropospheric value. On the other hand, Δ14CO2 values from tropopause up to about 18(±1)km for the sample collected on 16 July (samples 1–4) showed a large gradient from −62 to 21‰. The next sample in the profile, corresponding to about 18(±1)–22(±2)km (one sample from each profile), shows slight enrichment of 80±20‰. The last section from both profiles, containing air from the upper stratosphere, was contaminated with pre-fill air.

Publications Copernicus
Download
Short summary
Here we describe the determination of C-14 concentration in stratospheric CO2 samples collected using the AirCore sampling method. Two stratospheric AirCore profiles, collected in Sodankylä, were used for this study. The stratospheric profile was divided into six sections. CO2 from each section was extracted and converted to graphite for the determination of C-14 using AMS. Through this study, we show that the AirCore is a viable and valuable sampling method for stratospheric C-14 measurements.
Here we describe the determination of C-14 concentration in stratospheric CO2 samples collected...
Citation
Share